【STM32 Cotex-M3处理器系列编程】时基定时器

void Delay(unsigned int x);

unsigned int TimingDelay;

int main(void)

{

SystemInit();//装备体系时钟

RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOC, ENABLE);//使能APB2外设时钟

RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_GPIOB | RCC_APB2Periph_GPIOC | RCC_APB2Periph_GPIOD,ENABLE);//IO口使能设置

GPIO_InitTypeDef GPIO_InitStructure; //界说I/O口结构体

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_6;

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;

GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;

GPIO_Init(GPIOC, &GPIO_InitStructure);

GPIO_ResetBits(GPIOC, GPIO_Pin_6);

if (SysTick_Config(72000000 / 100)) //每10ms中止一次

{

while (1);

}

while(1)

{

GPIO_SetBits(GPIOC, GPIO_Pin_6);

Delay(100); //100*10ms=1s

GPIO_ResetBits(GPIOC, GPIO_Pin_6);

Delay(100); //100*10ms=1s

}

}

void Delay(unsigned int x)

{

TimingDelay=x;

while(TimingDelay!=0);

}

void TimingDelay_Decrement(void)

{

if (TimingDelay != 0x00)

{

TimingDelay–;

}

}

//以下是报错函数

#ifdef USE_FULL_ASSERT

void assert_failed(uint8_t* file, uint32_t line)

{

while (1)

{

}

}

#endif